Create Zones can be used to specifically include sections of a given document in text inspections (excluding all other text) and compare them directly to the corresponding portions in the other panel.

To create a zone:

  • Click the Create Zones icon below the Master or Sample panel.
  • Click and drag the crosshairs icon that appears as the cursor over the text to be included. The text is highlighted and an ID is assigned.
  • Highlight the corresponding text in the Sample. A corresponding ID is assigned.
    NOTE:
    The Zoning sub-panel pops up in the Sample panel as a guide for which matches are available. Clicking on a match zooms in on that selection.
  • Create new zones by clicking and dragging separate portions of text in each panel and repeating the overall process.

To add to a zone:

  • Right-click on a zone that has already been selected, prompting the “Context” menu to appear.
  • Select Add.
  • Click and drag the cursor over a new portion of text. 
  • The same number designation of the original zone appears at the top of the new selection.
  • Repeat the process in the other panel if necessary.

To clear a zone:

  • Right-click on a zone that has already been selected, prompting the “Context” menu to appear.
  • Select Clear to delete a zone on either panel.
    NOTE: Clear
    also deletes the original zone if you had right-clicked on an added portion.
  • Select Clear All to delete all zones in both panels.
Did this answer your question?