To scan a file in either the Master or Sample panel .

  • Click Load from Scanner > Select Source.
  • Select the applicable scanner from the Scanner Selection window and click Select. 
  • Click Load from Scanner  > Scan Master to scan the Master document. Once scanned, the image loads in the Master panel.
  • Click Load from Scanner > Scan Sample to scan the Sample document. Once scanned, the image loads in the Sample panel.

You can also double-click in the Master or Sample panel.
Both options launch the load-file window.
NOTE: The Master and Sample files must be rasterized at the same DPI value. If they aren't an error message will notify you of the discrepancy. 

Meanwhile, if the selected DPI of a file you are loading is different than the Desired DPI in the profile being used, a message asking to change the DPI will appear. Click Yes to change the DPI to the prescribed amount or No to move ahead with the value you had set. 

Did this answer your question?